Configuration: Four Hdds Using One Lsi 1064 Controller - Fujitsu PRIMERGY SX940 Manual

Different configurations
V
CAUTION!
All unused cable ends have to be equipped with protective caps to avoid
short curcuits!
Ê Lay the unused cable ends of the two SAS cables at suitable locations.
5.1.2 Configuration: Four HDDs using one LSI 1064
controller
Ê Remove the storage blade as described in
blade" on page
Ê Open the storage blade as described in
on page 14.
Prerequisites
No controller installed, HDDs not connected.
Figure 11: Configuration: Four HDDs using one LSI 1064 controller
Ê Plug the controller into the contact strip (1) of the main board #1 and fix it
with a screw C26192-Y10-C68 (blue circle).
Ê Plug the connector HOST of the lower SAS cable into the SAS connector (2)
on the controller 1.
SX940
13.
1
5
section "Removing the storage
section "Opening the storage blade"
2
Review
ControllerLSI 1064
3
4
25