Table of Contents
Advertisement
Different configurations
Ê Plug onto the connector P2 of the lower SAS cable a protective cap and lay
the unused cable end at suitable location.
Cabling of controller #2
Ê Plug the controller into the contact strip of the main board #2 and fix it with
a screw (as mounting controller #1).
Ê Plug the connector HOST of the upper SAS cable into the SAS connector
MLC1 (4) on the controller #2.
Ê Plug the connector P1 of the upper SAS cable into the connector on the HDD
diskbay 0/1 (5).
Ê Plug onto the connector P2 of the upper SAS cable a protective cap and lay
the cable end at suitable location.
3
2
2
1
Figure 21: Position of the jumper: Four HDDs using two LSI 1064 controllers
I
Make sure that the jumpers on both HDD diskbays are in position 1-2
(blue circles).
SX940
Review
Mixed installation
35
Advertisement
Table of Contents
