Configuration: Four Hdds Using Two Lsi 1064 Controllers - Fujitsu PRIMERGY SX940 Manual

Table of Contents

Advertisement

Different configurations
5.1.3
Configuration: Four HDDs using two LSI 1064
controllers
Ê Remove the storage blade as described in
blade" on page
Ê Open the storage blade as described in
on page
14.
Prerequisites
No controller installed, HDDs not connected.
Figure 13: Configuration: Four HDDs using two LSI 1064 controllers
Cabling of controller #1
Ê Plug the controller into the contact strip (1) of the main board #1 and fix it
with a screw C26192-Y10-C68 (blue circle).
Ê Plug the connector HOST of the lower SAS cable into the SAS connector (2)
on the controller #1.
Ê Plug the connector P1 of the lower SAS cable into the connector on the HDD
diskbay 2/3 (3).
Ê Plug onto the connector P2 of the lower SAS cable a protective cap and lay
the unused cable end at suitable location.
SX940
13.
1
section "Removing the storage
section "Opening the storage blade"
4
2
Review
ControllerLSI 1064
5
3
27

Advertisement

Table of Contents
loading

Table of Contents