Table of Contents
Advertisement
Controller
4.2.1
Replacing controller
The replacing of a controller wil be described exemplary at the following config-
uration:
– One LSI 1064 controller for two HDDs
I
For the further configurations see
page 23
Ê Remove the storage blade as described in
blade" on page
Ê Open the storage blade as described in
on page 14
2
Figure 5: Removing the controller
Ê Remove the SAS cable from the controller (1).
I
Do not bend SAS cables!
Ê Remove the screw (blue circle).
Ê Pull the controller out of the contact strip of the main board (2).
Installing will be done in the reverse order.
18
13.
Review
Replacement routines
chapter "Different configurations" on
section "Removing the storage
section "Opening the storage blade"
1
SX940
Advertisement
Table of Contents
