Table of Contents
Advertisement
719PRO
Users Manual
Pressure Switch Test
Connect a pressure switch to the Product as shown in
Figure 8.
Use low volume tubing when possible
Figure 8. Pressure Switch Connection
26
To do a pressure switch test:
1.
Change the setup to Setup 4 (default switch test)
listed under "Setups" in the MORE configuration
menu choices. The upper display is set to [P1] ST, all
other displays are off.
Pressure
The pressure switch test can be done with these
Switch
functions: [P1] ST, or EXT ST.
Use low-volume tubing when possible.
2.
Connect the Product to the switch with the pressure
switch terminals to the pressure switch contacts (de-
energized dry contacts). The polarity of the terminals
does not matter. Connect the pump from the Product
to the input of the pressure switch.
3.
Make sure the vent on the pump is open.
4.
Zero the Product if necessary.
5.
Close the vent after the Product is zeroed. If a
normally closed switch, the top of the display shows
"CLOSE".
6.
Apply pressure with the pump slowly until the switch
opens.
hix017.eps
Note
Hide quick links:
Advertisement
Table of Contents
