Activate And Deactivate A Display; Set The Rtd Probe Type - Fluke 719PRO User Manual

Activate and Deactivate a Display

From the Display Main Menu, push  to access the
Display Activation Menu.
The {display} option can be used to select which display
is active. The selected display and current on/off state are
shown in the lower display as seen below.
Push  to save the changes and go back to the Main
Menu. When a display is deactivated, its configuration is
saved. When the display is activated, its configuration is
compared against the configurations of the other
currently-active displays. If the configurations are in
conflict, the recalled display configuration is changed to
prevent conflict. If all three displays are deactivated, the
LOWER display comes on automatically.

Set the RTD Probe Type

Push  from the Probe Type Main Menu to access the
RTD Probe selections.
hix033.eps
There are four probe types to select from:
P100-385 (select this type for use with Fluke-
720RTD probe accessory)
P100-392
P100-JIS
CUSTOM
Push  to select the necessary probe type (see the
hix034.eps
figure below). Push  to store the change and go to the
Main Menu.
The default probe type is PT100-385.
Pressure Calibrator
Product Features
hix035.eps
Note
hix036.eps
17