Main Menu Functionality; Set The Active Display; Set Active Display Parameters - Fluke 719PRO User Manual

Main Menu Functionality

There are three options on the Main Menu, shown below:

Set the Active Display

The active display is indicated by the center option on the
Main Menu. Push  from this menu to toggle the active
display (UPPER, MIDDLE, or LOWER).

Set Active Display Parameters

To set the parameters of the active display, push  from
the Main Menu to go to the Active Display Configuration
menu, shown below:
Push  to toggle through the selections for each
parameter of the active display. The first parameter is
Mode. Since voltage, current, and switch test modes all
use the same jacks, two of these functions cannot be
used at the same time. The ability to select some
functions is limited based on what is already selected on
a different display.
Push  to change to the NEXT active display parameter.
Only RTD and Pressure modes have a second
parameter. RTDs can be read in Celsius or Fahrenheit.
Pressures can be read in 15 engineering units.
With a single display, the modes below are available.
Push  to access each mode:
hix021.eps
[P1] = Pressure internal sensor
[EXT] = Pressure with external pressure module
[P1] ST = Switch Test with left side sensor
[EXT] ST = Switch Test with external pressure
module
hix022.eps
Pressure Calibrator
Product Features
11