Wall Plate DigitalMedia™ CAT Transmitters
Setup
16 • Wall Plate DigitalMedia™ CAT Transmitters: DM-TX-200-2G/400-3G
Network Wiring
When wiring the DM network, consider the following:
NOTE: DMNet wiring and Cresnet
•
Use Crestron Certified Wire.
•
Use Crestron power supplies for Crestron equipment.
•
Provide sufficient power to the system.
CAUTION: Insufficient power can lead to unpredictable results or damage
to the equipment. Please use the Crestron Power Calculator to help calculate
how much power is needed for the system (www.crestron.com/calculators).
•
For DigitalMedia CAT wiring, use DM-CBL DigitalMedia Cable. Up to
two DM Repeaters (model DM-DR, sold separately) may be required. Refer
to the latest version of the Crestron DigitalMedia Design Guide (Doc. 4789)
for complete wiring guidelines.
For more details, refer to "Check Network Wiring" on page 34.
Identity Code
NOTE: In the SIMPL™ Windows program, when a DM-TX-200-2G or
DM-TX-400-3G is dropped onto an input card of a DM switcher, its IP ID is
assigned automatically and does not require additional programming. Use the
information below when a DM-TX-200-2G or DM-TX-400-3G is dropped directly
into an Ethernet slot on the control system in SIMPL Windows, without a DM
switcher.
The IP ID is set within the DM-TX-200-2G's and DM-TX-400-3G's IP table using
Crestron Toolbox. For information on setting an IP table, refer to the Crestron
Toolbox help file. The IP IDs of multiple DM-TX-200-2G and DM-TX-400-3G
devices in the same system must be unique.
When setting the IP ID, consider the following:
•
The IP ID of each unit must match an IP ID specified in the SIMPL
Windows program.
•
Each device using IP to communicate with a control system must have a
unique IP ID.
Crestron DM-TX-200-2G/400-3G
®
wiring are not compatible.
Operations & Installation Guide – DOC. 6949B