SpectraLink Corporation
Message
Network Busy
All APs are full or busy
No GW Response
Wireless Telephone not registered
on NetLink Telephony Gateway
NetLink Telephony Gateway is not
working
No LAN connection at the AP or
NetLink Telephony Gateway
No IP Address
Invalid IP
No Net Access
Cannot authenticate / associate with
AP
No Net Found
This indicates any of the following:
•
•
•
•
•
•
No Reg Domain
Regulatory Domain not set
No PBX
No communication with host
telephone system.
PN: 72-1065-09-E.doc
Setup and Administration–NetLink e340 & i640 Wireless Telephone
NetLink Telephony Gateway and SpectraLink Radio Protocol
Description
No radio link
No ESSID – Auto-learn not
supported (or)
Incorrect ESSID
AP does not support appropriate
data rates
Out of range
Incorrect WEP settings
Action
Try the call again later.
Verify that the NetLink Telephony
Gateway is properly configured.
Verify that the NetLink Telephony
Gateway is powered on. If so,
follow standard NetLink Telephony
Gateway troubleshooting
procedures.
Verify NetLink Telephony Gateway
connection to LAN and all APs.
Check the IP address of the
Wireless Telephone and re-
configure if required.
Verify the AP configuration.
Verify that all the WEP settings in
the Wireless Telephone match
those in the APs.
Verify that the AP is turned on.
Verify the ESSID of the wireless
LAN and enter or Auto-learn it
again if required. See Wireless
Telephone Configuration section.
Check the AP configuration against
Configuration Note for AP.
Try getting closer to an AP. Check
to see if other Wireless
Telephones are working within the
same range of an AP. If so, check
the ESSID of this Wireless
Telephone.
Verify that all the WEP settings in
the Wireless Telephone match
those in the APs.
Configure the Regulatory Domain
of the Wireless Telephone
Displays before the system has
synchronized ports with the host
telephone system. Should
disappear when the ports are
correctly wired and programmed.
Make sure the proper PBX switch
has been selected within the
NetLink Telephony Gateway.
Page 34
Need help?
Do you have a question about the NetLink e340 and is the answer not in the manual?