Table of Contents
Advertisement
Figure 94 Security Settings > Firewall > Access Control > Add/Edit
The following table describes the labels in this screen.
Table 71 Security Settings > Firewall > Access Control > Add/Edit
LABEL
General
Filter Name
Select Source
Device
Source IP Address
Select Destination
Device
Destination IP
Address
Select Protocol
Protocol
Custom Source Port This field is displayed only when you select Specific Protocol in Select
P-873HNU(P)-51B User's Guide
DESCRIPTION
Enter a descriptive name of up to 16 alphanumeric characters, not including
spaces, underscores, and dashes.
You must enter the filter name to add an ACL rule. This field is read-only if you
are editing the ACL rule.
Select the source device to which the ACL rule applies. If you select Specific
IP Address, enter the source IP address in the field below.
Enter the source IP address.
Select the destination device to which the ACL rule applies. If you select
Specific IP Address, enter the destiniation IP address in the field below.
Enter the destination IP address.
Select the transport layer protocol that defines your customized port from the
drop-down list box. The specific protocol rule sets you add in the Security
Settings > Firewall > Protocol > Add screen display in this list.
If you want to configure a customized protocol, select Specific Protocol.
This field is displayed only when you select Specific Protocol in Select
Protocol.
Choose the IP port (TCP/UDP, TCP, UDP, or ICMP) that defines your
customized port from the drop-down list box.
Protocol.
Enter a single port number or the range of port numbers of the source.
Chapter 15 Firewall
195
Advertisement
Table of Contents
