Table of Contents
Advertisement
22
en | Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts
WARNING!
Ensure that you connect the outgoing power supply wires to the P107 heater connectors (HN
and HL). The heater power (XF103) fuse can handle a higher amperage (3.15 A) than the
camera power (XF102) fuse (2.0 A).
6.
7.
8.
Figure 2.8 VG4-PA0 Power Supply Box
1
2
3
4
9.
2.6
Attach Pendant Arm to Power Supply Box
The bottom hinge pin of the Pendant Arm is provided with a Hinge Pin Stop to hold the hinge
open while attaching the arm to the Power Supply Box.
F.01U.273.797 | 5.0 | 2012.08
Route the 24 VAC outgoing power supply wires into the VG4-PA0 power supply box
through the conduit fitting on the left side of the box.
Cut and trim the 24 VAC power and ground wires with sufficient slack to reach their
connector terminal in the box, but not so long as to be pinched by or to obstruct closing
the cover door.
Attach the supplied 3-pin power plug to the incoming 24 VAC power wires in the box, as
illustrated below.
P101
24V
NC
24V
1 2 3
GND TXD RXD
6 5 4 3 2 1
6 5
6 5
5
5
5
5 4
Incoming 24 VAC Power Supply Wires (from VG4-PSU1/VG4-PSU2 power supply box)
Ground Wire
P101 Connector
Ethernet (Video and Control)
Follow the instructions in Section 2.6 Attach Pendant Arm to Power Supply Box, page 22, to
continue the installation.
Installation Manual
J102
(LED)
P106
P105
C+ C-
GND TXD RXD
C+ C-
4
4 3 2 1
4
4
4
4
6 5 4 3 3
6 5 4 3 2 1
3
2 1
AutoDome 800 Series HD PTZ Camera
Bosch Security Systems, Inc.
Advertisement
Table of Contents
