Table of Contents
Advertisement
88
en | Configuring the AutoDome 800 Series
Autopan Right Limit
Sets the right Auto Pan limit of the camera. Use the preview window to move the camera to
the right pan limit and click the button. The camera will not move past this limit when in Auto
Pan Between Limits mode (AUX 2 ON).
Tilt Up Limit
Sets the upper tilt limit of the camera.
Tilt Limits
Click the Reset button to clear the upper tilt limit.
Tour A / Tour B
Starts and stops the recording of a recorded (guard) tour.
The AutoDome can make up to two (2) recorded tours. A Recorded Tour saves all manual
camera movements made during the recording, including its rate of pan, tilt and zoom speeds
and other lens setting changes.
Note: You can save a total of 15 minutes of recorded actions between the two tours.
To record a tour:
1.
2.
3.
4.
5.
Compass
The VG5 AutoDome allows a user to display the compass heading of the camera in the lower-
right corner of the image display. The AutoDome displays the The cardinal or intercardinal (N,
NE, E, SE, S, SW, W, NW) heading in which the camera is pointing.
NOTICE!
The compass feature is not compatible with Bosch Intelligent Tracking. If Intelligent Tracking
is activated, the camera automatically disables the display of the compass heading. Once
Intelligent Tracking is deactivated, the camera returns the compass heading to the display.
You must first calibrate the AutoDome to North before the camera displays accurate compass
headings. The AutoDome uses this calibration, usually set to magnetic North, as the zero
degree pan position and as the North compass heading. The AutoDome then displays the
compass heading based on the number of degrees from the North calibration point.
To set the North calibration point:
1.
2.
3.
7.25
Diagnostics
Accesses the Built-in Self Test (BIST). Click the BIST button to display the number of times
the AutoDome 800 Series:
–
–
–
–
F.01U.273.797 | 5.0 | 2012.08
Click the Start Recording button. The system prompts you to overwrite the existing tour.
Click Yes to overwrite the existing tour movements.
Click the View Control link, under the image cameo, to access the directional and zoom
controls.
Use the View Control dialog box to make the necessary camera movements.
Click the Stop Recording button to save all actions.
Determine the North compass heading, then move the camera to that position.
Click the Set North Compass Point button to set the calibration point.
Click the On radio button for the Compass parameter.
performed a homing event.
failed to home properly.
restarted.
lost video.
Installation Manual
AutoDome 800 Series HD PTZ Camera
Bosch Security Systems, Inc.
Advertisement
Table of Contents
