Bosch VG5 800 SERIES Installation Manual page 44

44 en | Installing Roof Parapet and Pipe Mounts
Figure 3.7 VG4-A-9230 Parapet Mount
1
2
3
4
5
7.
8.
9.
10. Thread the Dome Cap onto the down pipe and tighten securely. See the illustration
WARNING!
You must thread the Dome Cap onto the Down Pipe until it is tight. Failure to do so can result
in damage, serious injury, or death.
Figure 3.8 Attach Dome Cap
1
2
11. Run a bead of RTV Silicon sealant around the down pipe/Dome Cap interface to seal any
F.01U.273.797 | 5.0 | 2012.08
End Cap with O-ring
Parapet Pipe Arm
1/4-20 SS Cap Screw
Down Pipe
10-24 SS Pan Head Screw
Fold the Ethernet and power wires back at the front end of the arm and route them down
and out through the Down Pipe. Then replace the End Cap.
Wrap at least five layers of Teflon tape around the Down Pipe threads.
Apply the supplied thread sealant to the Down Pipe threads:
– Make sure all surfaces are clean and dry.
– Apply a bead of sealant completely around the leading threads of the male fitting.
– Force the adhesive into the threads to thoroughly fill all voids.
below.
Thread Sealant or tape
Dome Cap
gaps between the down pipe and the Dome Cap.
Installation Manual
AutoDome 800 Series HD PTZ Camera
Bosch Security Systems, Inc.