Bosch VG5 800 SERIES Installation Manual page 24

24 en | Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts
Figure 2.10 Pendant Arm connections to Power Supply Box
1.
2.
3.
Control/Audio
Alarm Inputs
WARNING!
Do not connect the RJ45 connector unless using UTP video or Ethernet.
4.
5.
F.01U.273.797 | 5.0 | 2012.08
1 2 3
Attach the earth ground wire (item 1 in the illustration above) to the grounding screw on
the left side of the power box.
Connect the 6-pin Control/Audio cable, installed previously, to its mating connector P106
in the power box.
Connect the 6-pin Control to Dome Plug from the Pendant Connector Harness to its
matting connector P105 in the power box.
Coax Video
(not used)
Alarm Outputs
Connect the 5-pin, 24 VAC to Dome Plug from the Pendant Connector Harness to its
corresponding color mating connector P107 on the right side of the box.
To connect alarm Inputs and the alarm output, connect the 4-pin Alarm Out and the 6-pin
Alarm In connectors from the Pendant Connector Harness to their mating connectors,
installed previously, to the incoming alarm wires.
Installation Manual
AutoDome 800 Series HD PTZ Camera
24 VAC Power Ethernet Video and
Control
Relays Grounding Strap
Bosch Security Systems, Inc.