Table of Contents
Advertisement
AutoDome 800 Series HD PTZ Camera
Ref. Description
3
4
5
6
7
8
9
10
11
12
3.7.1
Connecting Wires to the Pipe Interface Board
The Pipe Interface Board contains all of the connectors for control, data, image, and power
wires. Follow the procedures below to make the proper connections.
WARNING!
Use a 24 VAC Class 2 power supply only.
1.
2.
3.
CAUTION!
To protect the AutoDome from damage due to cold temperatures, ensure that you connect the
24 VAC heater power wires to the P101 connector.
4.
Bosch Security Systems, Inc.
6-pin Alarm Input Flying Lead
Alarms In (1-2)
4-pin Alarm Outputs Flying Lead
Relay Out (1)
100 Ω Resistor
Audio
Not Used
Not Used
Dome Power
Heater Power
RJ45 Ethernet Video and Control
To AutoDome
Attach an RJ45 connector plug to the Ethernet cable and connect the plug to its mating
connector J101 on the Pipe Interface Board.
Attach the control data in/out wires to their respective terminals on the P105 connector
on the Pipe Interface Board. See Figure 3.10, Page 46, for an illustration of these
connections.
Connect the 24 VAC power wires to the P101 connector on the Pipe Interface Board. If
this model has a heater, connect the 24 VAC heater power wires to connector P107.
To connect alarm inputs and outputs, attach the supplied 6-pin Alarms In and the 4-pin
Alarms Out connector plugs with flying leads to the appropriate alarm wires. Then
connect the plugs to their mating connectors P103 and P102 on the Pipe Interface Board.
Installation Manual
Installing Roof Parapet and Pipe Mounts | en
Connector
Wire Gauge
P103
P102
P105
P105
P104
P104
P101
AWG 18-14
P107
AWG 18-14
J101
47
Pin
Description
1
Alarm In 1
2
Alarm In 2
3
Not used
4
Not used
5
Not used
6
Alarm Ground
1
Not used
2
Not used
3
Relay Out 1
4
Relay Ground
1
Audio- (C-)
2
Audio+ (C+)
3
NC
4
NC
5
NC
NC
3
Dome 24 VAC
2
Earth Ground
1
Dome 24 VAC
2
Heater 24 VAC
1
Heater 24 VAC
F.01U.273.797 | 5.0 | 2012.08
Advertisement
Table of Contents
