Table of Contents
Advertisement
42
en | Installing Roof Parapet and Pipe Mounts
No.
P101
P105
P106
P107
Table 3.1 Power Supply Box Connections
3.5
Installing the VG4-A-9230 Roof Parapet Mount
This section details the installation steps for the Roof Parapet Mount. If you are installing a
pipe mount, see Section 3.6 Installing the VG4-A-9543 Pipe Mount, page 45, for instructions.
Figure 3.5 VGA-A-9230 Parapet Roof Mount
1.
NOTICE! Allow enough room below the Parapet Mount Bracket to route the video, control and
alarm wires up through the Parapet arm. In certain installations you may have to lift the
Parapet arm for the AutoDome to clear the top of the wall when it is swung into position.
Provide enough slack in the wires to rotate the pipe arm over the roof and back when camera
maintenance is required.
2.
F.01U.273.797 | 5.0 | 2012.08
Connector
Pin 1
Ground
Grounding Screw
115/230 VAC or
Line
24 VAC Power In
Data/Audio
Audio
Not Used
24 VAC Power
Dome
(Arm Harness)
24 VAC
Determine the wall location on the roof for the AutoDome and use the Parapet wall
mount bracket as a template to mark the hole locations.
Prepare the mounting surface for the type of fastener by drilling holes for the mounting
anchors as required.
Installation Manual
AutoDome 800 Series HD PTZ Camera
Pin 2
Pin 3
Pin 4
NC
Neutral
Audio
Earth
Not Used
Ground
Dome
Earth
Heater
24 VAC
Ground
(24 VAC)
Pin 5
Pin 6
Heater
(24 VAC)
Bosch Security Systems, Inc.
Advertisement
Table of Contents
