Table of Contents
Advertisement
Installing the Switch
To install the switch, perform the following procedures:
1. Remove all equipment from the package and store the packaging in a safe
place.
2. If you are installing the switch as a standalone unit, attach the four rubber
feet to the base of the unit, placing one rubber foot in each corner. (For
rack-mount chassis installation, do not attach the feet.)
3. Configure the DIP switches on the rear panel of the unit. Refer to Figure
11 and Figure 12 for the location of the switches and Table 6 and Table 7
for the possible settings.
Table 6 DIP Switch Settings for the AT-FS201 and AT-FS202 Switches
Port
Speed (Mbps)
Up
10
Down
100
Table 7 DIP Switch Settings for the AT-FS203 Switch
Port
1
Speed (Mbps)
Up
10
Down
100
2
1
Duplex Mode
Half
Full
2
1
Duplex Mode
Half
Full
AT-FS200 Series Installation Guide
2
2
Auto-neg
Off
On
2
1
Auto-neg (only)
Off
On
Bytes
1522
1518
2
Bytes
1522
1518
17
Advertisement
Table of Contents
