Warranty Registration; Troubleshooting; Is The Switch Receiving Power - Allied Telesis AT-FS201ST/FS1 Installation Manual

Installing the Switch
AUTO NEG
LNK
TX
RX 100
FD
COL
FS203 FAST ETHERNET SWITCH

Warranty Registration

When you finish the installation, register your product by completing the
enclosed warranty card and sending it in, or by visiting our web site at
www.alliedtelesyn.com/forms/warranty.htm and completing the on-line
registration.

Troubleshooting

This section contains guidelines for troubleshooting the unit should a problem
occur.
Note
Whenever the speed and/or duplex mode are changed during or after
power ON, power OFF then power back on the switch to load the new
configuration.

Is the Switch Receiving Power?

❑
Verify that the Power LED is lit.
❑
If the Power LED is not ON, check the AC power adapter to verify that
the adapter is plugged into a functioning wall outlet and that the DC
power cord is properly inserted into the switch's power connector.
20
10Base-T/
10Base-T/
100Base-TX
100Base-TX
MDI MDI-X MDI MDI-X
PORT 1 PORT 2
IEEE 802.3 /802.3U
10Base T/
100Base-TX
MDI
PORT 1
Figure 13 MDI/MDI-X Switch
AUTO NEG
PWR
LNK
TX
RX 100
FD
COL
10Base-T/
100Base-TX
MDI-X MDI
PORT 2
MDI-X