Table of Contents
Advertisement
Installing the Switch
Planning the Installation
Be sure to observe the following guidelines when planning the installation of
your Ethernet switch.
❑
The end node connected to the fiber optic port on an AT-FS201ST or
AT-FS202SC switch must be able to operate at 100 Mbps.
❑
The end node connected to the twisted pair port(s) can operate at
either 10 Mbps or 100 Mbps.
❑
The end node connected to a port on the switch can be a network
adapter card, repeater, router, hub, or another switch.
❑
The twisted pair cabling must be kept away from sources of electrical
noise, such as radios, transmitters, power lines, broadband amplifiers,
electrical motor, and fluorescent fixtures.
❑
Refer to Table 3 for the cabling specifications for the twisted pair
port(s).
Table 3 10/100Base-TX Twisted Pair Cabling Specifications
Operating Mode
10Base-T
100Base-TX
14
Cable Type
Shielded or unshielded Category 3 or better
Shielded or unshielded Category 5 or better
Maximum
Distance
100 m (328 ft)
100 m (328 ft)
Advertisement
Table of Contents
