Maintenance And Troubleshooting - Healthrider Health Rider R1000t Bike User Manual

MAINTENANCE AND TROUBLESHOOTING

Inspect and properly tighten all parts of the exercise
cycle regularly. To clean the exercise cycle, use a
soft, damp cloth. To prevent damage to the console,
keep liquids away from the console and keep the con-
sole out of direct sunlight.
HOW TO ADJUST THE DRIVE BELT
If you can feel the pedals slip whilst you are pedaling,
even when the resistance is adjusted to the highest
level, the drive belt may need to be adjusted. To
adjust the drive belt, you must first remove the Right
Side Shield (27). Using an adjustable spanner, turn
the Right Pedal (21) counterclockwise and remove it.
Next, remove the indicated M4 x 25mm Screws (58).
Turn the Right Crank Arm (23) so it is pointing toward
the front of the exercise cycle, and then slide off the
Right Side Shield.
27
58
23
21
58
Next, turn the indi-
cated M8 Nylon
Locknut (38) until
the Drive Belt (47)
is properly tight-
ened. Then, reat-
tach the right side
shield.
PULSE SENSOR TROUBLESHOOTING
If the chest pulse sensor does not function properly,
see CHEST PULSE SENSOR TROUBLESHOOTING
on page 9.
If the handgrip pulse sensor does not function properly,
see step 5 on page 14.
24
47
38