Bowflex Xtreme 2 Assembly Instructions Manual page 16

14
Figure 18 - Lat Pulley Housing
Step 18 - Cable & Pulley Routing
Connect the Pulleys and Cables to the Lat Pulley Housing
Locate the following items:
• (2) Pulleys (from Step 17)
• (1) 3/8" X 4 1/2" Hex Head Bolt (uninstalled during Step 17)
• (1) 3/8" Washer (uninstalled during Step 17)
NOTE: Connecting these Cables is much easier with a second person assisting you.
1. While continuing to hold both Cables in place (from Step 17), align both (2) Lat Pulleys as shown in Figure 18. Slide both
Pulleys back into the slot in the Lat Pulley Housing, lining up the bolt holes in the Pulleys with the bolt holes in the Lat
Pulley Housing.
2. Place the 3/8" Washer over the (1) 3/8" X 4 1/2" Hex Head Bolt that you removed at the start of Step 17, and slide
that bolt through the aligned holes in the Lat Pulley Housing and Lat Pulleys, as shown in Figure 18.
Tighten all hardware.
NOTE: You will most likely need to push the Power Rod® Unit out of the way for this step. They are not
pictured for the sake of clarity.
Referred to as:
(2) Pulley
Towards the Front
of the Machine
Lat Pulley Housing
Washer
Hex Head Bolt
Towards the Rear of
the Machine