Attach Lower Lat Tower; Seat Support Rail - Bowflex Xtreme 2 Assembly Instructions Manual

5
Step 3: Attach the Lower Lat Tower to the Base
Figure 3
Frame Assembly
Lower Lat
Tower Assembly
Locate the following items:
F
• From Step 1 - Base Frame Assembly
• From Step 2 - Lower Lat Tower Assembly
O
• Item #F - (2) 3/8" X 3/4" Hex Head Bolts
• Item #O - (2) 3/8" Washers
With the Base Frame Assembly (from Step 1) on the
floor, center the Lower Lat Tower Assembly over the
4
Rear Cross Bar (Item #4), as shown in Figure 3. Place the
Lower Lat Tower onto the bracket on the Rear Cross Bar.
Place (2) 3/8" Washers (Item #O) over the ends of (2) 3/8"
X 3/4" Hex Head Bolts (Item #F) - one washer per bolt.
Base Frame
Assembly
Attach the Lower Lat Tower to the Rear Cross Member
with the bolts and washers, as shown in Figure 3.
Do not tighten hardware from Step 3 at this time.
Step 4: Attach the Seat Support Rail to the Base
Figure 4
Frame Assembly
O
F
Locate the following items:
• From Step 3 - Base Frame (Main) Assembly
• Item #7 - Seat Support Rail 7
• Item #F - (2) 3/8" X 3/4" Hex Head Bolts
• Item #O - (2) 3/8" Washers
5
Insert the Seat Support Rail (Item #7) into the bracket on
the Standing Platform (Item #1) and line up the connector
at the top of the Seat Support Rail with the bracket on the
1
Lower Lat Tower (Item #5), as shown in Figure 4.
Gently push the Seat Support Rail into place in the Lower
Lat Tower bracket.
Place (2) 3/8" Washers (Item #O) over the end of (2) 3/8"
X 3/4" Hex Head Bolts (Item #F) - one washer per bolt.
Loosely install the bolts with washers into the two side holes
at the top of the Seat Support Rail connector (see Figure 4).
Do not tighten hardware from Step 4 at this time.