Password Screen - ZyXEL Communications NBG6503 User Manual

Chapter 22 Maintenance
The following table describes the labels in this screen.
Table 65 Maintenance > General
LABEL
System Setup
System Name
Domain Name
Administrator
Inactivity Timer
Apply
Cancel

22.4 Password Screen

It is strongly recommended that you change your Router's password.
If you forget your Router's password (or IP address), you will need to reset the device. See
22.8 on page 161
Click Maintenance > Password. The screen appears as shown.
Figure 112 Maintenance > Password
The following table describes the labels in this screen.
Table 66 Maintenance > Password
LABEL
Password Setup Change your Router's password (recommended) using the fields as shown.
Old Password
New Password
Retype to
Confirm
Apply
Reset
156
DESCRIPTION
System Name is a unique name to identify the Router in an Ethernet network.
Enter the domain name you want to give to the Router.
Type how many minutes a management session can be left idle before the
session times out. The default is 5 minutes. After it times out you have to log in
with your password again. Very long idle timeouts may have security risks. A
value of "0" means a management session never times out, no matter how long
it has been left idle (not recommended).
Click Apply to save your changes back to the Router.
Click Cancel to begin configuring this screen afresh.
for details.
DESCRIPTION
Type the default password or the existing password you use to access the system in this
field.
Type your new system password (up to 30 characters). Note that as you type a password,
the screen displays an asterisk (*) for each character you type.
Type the new password again in this field.
Click Apply to save your changes back to the Router.
Click Reset to begin configuring this screen afresh.
Section
NBG6503 User's Guide