Chapter 6 Easy Mode
Click Status to open the following screen screen.
Figure 28 Easy Mode: Status Screen
Go to
Network
Map
Screen
6.2 What You Can Do
You can do the following in this mode:
• Use this Navigation Panel
• Use the Network Map screen
gateway and whether it is connected to the Internet.
• Use the Control Panel
including wireless security, wireless scheduling and bandwidth management and so on.
• Use the Status Screen screen
Router, including the WAN IP, MAC Address of the Router and the firmware version.
6.3 What You Need to Know
Between the different device modes, the Control Panel
on which features are applicable to the mode:
• Router Mode: All Control Panel features are available.
• Access Point Mode: Only Power Saving and Wireless Security are available.
46
Navigation Panel
Status Screen
Control Panel
(Section 6.4 on page
(Section 6.5 on page
(Section 6.6 on page
(Section 6.7 on page
47) to opt out of the Easy mode.
47) to check if your Router can ping the
48) to configure and enable Router features,
55) to view read-only information about the
(Section 6.6 on page
48) changes depending
NBG6503 User's Guide