Chapter 20 Remote Management
20.3.2 System Timeout
There is a default system management idle timeout of five minutes (three hundred seconds). The
Router automatically logs you out if the management session remains idle for longer than this
timeout period. The management session does not time out when a statistics screen is polling. You
can change the timeout period in the System screen
20.4 WWW Screen
To change your Router's remote management settings, click Management > Remote
Management > WWW.
Figure 100 Management > Remote Management > WWW
The following table describes the labels in this screen
Table 63 Management > Remote Management > WWW
LABEL
Server Port
Server Access
Secured Client
IP Address
Apply
Reset
146
DESCRIPTION
You may change the server port number for a service if needed, however you must use the
same port number in order to use that service for remote management.
Select the interface(s) through which a computer may access the Router using this service.
Select All to allow all computes to access the Router.
Otherwise, check Selected and specify the IP address of the computer that can access the
Router.
Click Apply to save your customized settings and exit this screen.
Click Reset to begin configuring this screen afresh.
NBG6503 User's Guide