Mounting The Ap To A Dropped Ceiling; Figure 4. Attaching The Metal Slider To The Ap - ADTRAN 160 series Hardware Installation Manual

NetVanta 160 Series

Mounting the AP to a Dropped Ceiling

The NetVanta 160/161 AP is shipped with a metal ceiling mounting kit to mount the AP on the ceiling tile
separators of standard dropped ceilings. The plastic mounting bracket can be used to mount the AP to a drywall
ceiling or ceiling electrical box. Refer to
APs should be positioned for maximum throughput and range between other APs and wireless client devices.
Follow these instructions to mount the AP to a dropped ceiling:
Step
1 For the NetVanta 161 only: Install the antennas (sold separately) onto an appropriate antenna
port on the AP. The antenna ports are labeled 2.4G 1 through 3 or 5G 1 through 3.
2 Using the thumb screws only, carefully thread the antenna onto the appropriate connector until it
is secure. Repeat Steps 1 and 2 with the each antenna.
3 Lay the metal slider on the back of the AP in the orientation shown in
the slider to the back of the AP using the two small screws provided. After the screws are
tightened, the slider should slide back and forth clicking into each position.
4 In a suitable location away from obstructions, slide the tabs on the metal ceiling bracket over one
edge of a ceiling tile separator as shown in
5 Slide the moveable section into place and tighten the screw to secure it.
6 Position the AP so that the two tabs on the ceiling bracket locate in the slots in the AP (A). Push
the slider mounted on the AP across until it snaps, locking the AP to the bracket (B) as shown in
Figure 6 on page
61700416F1-34A
Mounting the AP on a Desktop on page 21
Mounting the AP to a Dropped Ceiling
24.
Tab
Slots
Metal Slider

Figure 4. Attaching the Metal Slider to the AP

Copyright © 2013 ADTRAN, Inc.
Action
Figure 5 on page 24.
Tab
Metal Slider
Unit Installation
for instructions. NetVanta
Figure 4 on page 23. Attach
23