Unit Installation
3.
UNIT INSTALLATION
The instructions and guidelines provided in this section cover hardware installation topics such as wall
mounting and supplying power to the unit.
To prevent electrical shock, do not install equipment in a wet location or during a
lightning storm.
Maximum recommended ambient operating temperature is 50
Installing the Antennas
The NetVanta 150 unit ships with two dual-band RP-SMA detachable antennas. These must be installed
before wall mounting the unit.
Step
1
Place either of the two antennas directly onto the antenna port on the rear panel labeled
Antenna 1. See Figure 2 on page 21 to locate the ports on the rear panel.
2
Twist the antenna onto the threads until it is secure.
3
Repeat step 2 with the second antenna, attaching it to the Antenna 2 port.
4
Once both antennas are secured, the antennas may be flexed at the joint to increase reception.
Mounting Options
The NetVanta 150 unit can be installed in a wallmount or tabletop configuration. The following section
provides step-by-step instructions for wall mounting.
22
NetVanta 150 Wireless Access Point ABG Hardware Installation Guide
Instructions for Attaching the Antennas
Copyright © 2006 ADTRAN, Inc.
°
Action
C.
61700412E1-34A