Mounting The Ap On A Desktop; Figure 2. Attaching The Vertical Stand - ADTRAN 160 series Hardware Installation Manual

NetVanta 160 Series
• Once APs have been installed and configured, use site survey and monitoring utilities supplied with the
client adapters to test signal strength at various locations. Modify the positioning of the APs and client
stations as required for optimum performance.
Make a note of the 12-character MAC address and serial number listed on the back of the
NetVanta 160/161 before mounting the AP to a wall or other surface. This information will
be required during configuration.

Mounting the AP on a Desktop

NetVanta APs should be positioned for maximum throughput and range between other APs and wireless client
devices. Follow these instructions to mount the AP on top of a shelf or table:
Step
1 Optional. For greater stability, drill holes in the table or shelf using the holes in the plastic
mounting bracket as a template. (See
mounting bracket.) Insert the four supplied screws through the plastic mounting bracket into the
table or shelf.
2 For the NetVanta 161 only: Install the antennas (sold separately) onto an appropriate antenna
port on the AP. The antenna ports are labeled 2.4G 1 through 3 or 5G 1 through 3.
3 With the top of the AP facing you (LEDs will be on your left), orient the plastic mounting bracket/
vertical stand with the hooks pointing to the right. (See
of the plastic mounting bracket.)
4 Insert the hooks into the vertical stand slots on the edge of the unit (see
until the hooks engage. You will hear a click.
5 The unit can now be set on a table or shelf.
LEDs
61700416F1-34A
Mounting the AP on a Table or Shelf
Action
Figure 2 on page 21

Figure 2. Attaching the Vertical Stand

Copyright © 2013 ADTRAN, Inc.
for a detailed view of the plastic
Figure 2 on page 21 for the a detailed view
Figure
Vertical Stand
Slots
Plastic Mounting Bracket/
Vertical Stand
Unit Installation
2) and press firmly
21