GarrettCom Magnum ST80 Stackable Installation And User Manual page 7

Stackable Personal Hubs
Switches:
Up-Link: MDI-X (Media Dependent Interface - Crossover) manual slide
switch, converts RJ-45 port #8 from a regular (=) user segment port to a
crossover (X) up-link port for on-off connection to a backbone or another
cascaded hub.
Stack Enable Switch: Manual slide switch to specify which Stackable
Personal Hub is the base of the stack. Exactly one hub should have its Stack
Enable switch in the "OFF" position (left). All other hubs in the stack should
have their Stack Enable switches set to the "ON" position (right).
Internal Termination Switch (ST80-B only): When switched to the right
position, allows BNC connection without a "tee" connector and a 50 ohm
terminator. When switched to left position, a "tee" connector is required.
LEDs:
PWR: GREEN when Proper DC power supplied to ST80.
COL: YELLOW when a transmit collision occurs on the hub.
LINK/TX (per port): GREEN when link established on port. Flickers as
port transmits packets.
POL/RX (per port): Flickers GREEN as port receives packets. Steady
GREEN when reversed polarity detected.
Packaging:
Enclosure: Rugged, high strength steel enclosure.
Suitable for vertical or horizontal mounting.
Any unit may be used stand-alone, or as either the base unit or an additional
Recessed LEDs to avoid damage, located with the RJ-45 ports for convenience.
Dimensions:
All models: 6.75 in x 4.0 in x 1.0 in (17.1 cm x 10.1 cm x 2.5 cm)
Weight:
All models:
Power Supply: 1.0 lb. (455 gr.)
Cooling method:
Convection
Agency Approvals:
Magnum ST80 is UL Listed (UL1950), CSA certified
115v 60 Hz Power Supply is UL Listed, CSA certified.
230v 50 Hz Power Supply is same, also GS approved.
Emissions: Meets FCC Part 15, Class A
Warranty:
Three years (see also Appendix A)
www GarrettCom com .
unit in a stack (two stacking / mounting clips and one IRB cable are
included with each unit)
1.3 lb. (600 gr.)
.
Installation and User Guide (04/01)
Made in USA
2