Using The Stack Enable Switch - GarrettCom Magnum ST80 Stackable Installation And User Manual

Stackable Personal Hubs
4.4

Using the Stack Enable switch

The Stack Enable switch of the ST80 is used to configure each unit of the
stack. If an ST80 is being used as a non-stacked unit, the Stack Enable switch must be in
the "OFF" position. When two or more ST80s are stacked, the bottom unit should be set
to the "OFF" position, and all other units should be in the "ON" position. For further
information about the Stack Enable switch, see Section 3.9, "Stacking the ST80s".
www GarrettCom com . .
Installation and User Guide (04/01)
21