Connecting Fiber Optic St-Type, "Twist-Lock; Connecting Fiber Optic Sc-Type, "Snap-In; Connecting Single-Mode Fiber Optic - GarrettCom Magnum 6K16V Installation And User Manual

Magnum 6K16V Managed Fiber Switch
IEEE Standard
Fiber:
100BASE-FX
100BASE-FX
small form factor
small form factor
Copper:
10BASE-T and 100BASE-TX twisted pair
3.2.1

Connecting Fiber Optic ST-type, "twist-lock"

The following procedure applies to installations using a PM with ST-type fiber
connectors. This procedure applies to ports using a 6K16V module, MST-type
port.
1. Before connecting the fiber optic cable, remove the protective dust caps from the
tips of the connectors on the PM. Save these dust caps for future use.
2. Wipe clean the ends of the dual connectors with a soft cloth or lint-free lens tissue
dampened in alcohol. Make certain the connectors are clean before connecting.
Note:
bands at regular intervals; you must use the color-coded strand on the
associated ports at each end of the fiber optic segment.
3. Connect the Transmit (TX) port (light colored post) on the Magnum PM to the
Receive (RX) port of the remote device. Begin with the color-coded strand of
the cable for this first TX-to-RX connection.
4. Connect the Receive (RX) port (dark colored post on the PM) to the Transmit
(TX) port
5. The LINK LED on the front of the PM will illuminate when a proper
connection has been established at both ends (and when power is ON in
the unit). If LINK is not lit after cable connection, the normal cause is
improper cable polarity. Swap the fiber cables at the PM connector to
remedy this situation.
3.2.2

Connecting Fiber Optic SC-type, "Snap-In"

The following procedure applies to installations using a PM with SC-type fiber
connectors, i.e., using 6K-MSC, 6K-SSC single-mode.
When connecting fiber media to SC connectors, simply snap on the two square male
connectors into the SC female jacks of the 6KPM until it clicks and secures.
3.2.3

Connecting Single-Mode Fiber Optic

When using single-mode fiber cable, be sure to use single-mode fiber port
connectors. Single-mode fiber cable has a smaller diameter than multi-mode fiber cable
www GarrettCom com .
Media Type
1
m
m Fiber
2
sgl.m Fiber
m 1
m Fiber
2
sgl.m Fiber
1
m
m Fiber
1
sgl.
m Fiber
1
mm = multi-mode
One strand of the duplex fiber optic cable is coded using color
of the remote device. Use the non-color coded fiber strand for this.
.
Installation and User Guide (06/04)
Max. Distance
220m ( ft)
GBIC-SXSC
5Km
2.0km (6,562 ft)
18.0km (95K ft)
2.0km (6,562 ft)
15 km
100m (328 ft)
2
sgl.m = single-mode
19
Port Module
GBIC-LXSC
6K6-MSC, -MST
SSC, SSCL
6K8-MTRJ, -MLC
6KP8V- SLC
6K8-RJ45