Standby/Hibernation Function; Battery Indicator - Panasonic CF-Y2 Series Reference Manual

Dealing with Problems (Advanced)

Standby/Hibernation Function

Unable to enter standby or hibernation
mode
Unable to automatically enter standby
or hibernation mode
The computer does not resume

Battery Indicator

The red indicator lights
If a USB device is connected to the computer (note: only for some USB
devices), remove the USB device temporarily. If the problem persists, restart
the computer.
It may take one or two minutes to enter standby or hibernation mode.
If there is a disc in the DVD-ROM & CD-R/RW drive that has been formatted
using B's CLiP, the computer will not enter standby or hibernation mode.
Remove the disc.
The computer may not enter standby mode properly and seems to be frozen in
the case that the computer is communicating via the modem. If this happens,
slide the power switch for four seconds or more to forcibly turn your computer
off.
If a peripheral is connected to the computer, disconnect the device.
If there is a disc in the DVD-ROM & CD-R/RW drive that has been formatted
using B's CLiP, the computer will not enter standby or hibernation mode.
Remove the disc.
When the internal LCD is closed, the computer may not enter standby or
hibernation mode. In order to activate standby or hibernation automatically
while using the computer with the internal LCD closed, set [Touch Pad] to
[Disable] in [Main] menu of the Setup Utility.
Did you disconnect the AC adaptor or the battery pack while the computer was
in standby mode? If the computer's power supply is disconnected while the
computer is in standby mode, all unsaved data will be lost.
Did you slide the power switch and hold it for four seconds or more? If you slide
the power switch and hold it for four seconds or more, the power will be turned
off forcibly. In this case, all unsaved data will be lost.
The battery level is very low (the charge is approx. 9% or less).
Connect the AC adaptor. You can use the computer when the battery indicator
light is orange. If you do not have an AC adaptor, save your data and power off
your computer. After replacing the battery pack with a fully charged one, turn
your computer on.
116