Replacing The Battery Pack - Panasonic CF-Y2 Series Reference Manual

Battery Power

Replacing the Battery Pack

2
Close all the application.
3
Use the "Battery Recalibration" to fully discharge the battery pack.
A Run the Setup Utility. (
Select [Battery Recalibration] from [Exit] menu and press Enter.
B
At the confirmation message, select [Yes] and press Enter.
C
Once the battery indicator turns green, the battery pack will be completely dis-
charged. It takes time
plete discharge of the battery from the fully charged state.
4
Allow the battery pack to charge until the battery indicator turns
*1
green .
*1
CF-Y2 series: Approximately 5.5 hours
CF-W2 series: Approximately 4.5 hours
The battery pack is a consumable item and therefore will require replacement (spare battery
page 31). If the battery operation time becomes noticeably short, and if performance is
not recovered even after executing Battery Recalibration, we recommend that the battery be
replaced.
CAUTION
Do not touch the terminals on the battery pack and the computer. The battery pack
may no longer function properly if the contacts are dirty or damaged. Also, the
computer may not operate properly.
The battery pack is not charged when it is first purchased. Be sure to charge it before
using it for the first time. When the AC adaptor is connected to the computer,
charging begins automatically.
Use only the specified battery pack (
In the standby mode, do not remove/change the battery pack. Removing the pack in
the standby mode will erase your data and may damage the computer.
page 96)
*1
until the power automatically goes off through the com-
page 31) with your computer.
40