Panasonic CF-Y2 Series Reference Manual page 119

Dealing with Problems (Advanced)
Connecting Peripherals
The cursor does not move from mouse
operations
The device will not operate if a
different mouse driver is installed
A PC Card does not work
USB floppy disk drives do not work as
a boot drive
You do not know the available RAM
module
Cannot tell whether the RAM module
has been correctly installed
Check your mouse connection.
A driver which is compatible with the connected mouse must be installed.
If the device does not operate when the driver is installed:
In the Setup Utility, set [Touch Pad] to [Disable].
When you install a different mouse driver, such as IntelliPoint for Microsoft's
IntelliMouse, the mouse driver currently installed in the computer may need to
be uninstalled. Use the following procedure to uninstall this driver.
A
Display the screen to uninstall the program.
Select [start] - [Control Panel] - [Add or Remove Programs].
B Uninstall [Synaptics Pointing Device Driver] and [TouchPadUtility]
separately.
Make sure the card is properly inserted.
Confirm that the card conforms to the PC Card Standard.
Note that after a driver (PC Card driver on other) is installed, the computer must
be restarted.
Check that the proper port settings have been made.
Read the operating instructions for the PC Card. Or, you may need to call the
manufacturer of the PC Card.
Try removing/reinserting the PC Card by following the proper procedure.
( page 63)
Confirm that a driver for your operating system has been installed.
ZV card, SRAM card, FLASH ROM card (except for an ATA interface) and card
requiring 12V are not supported.
Only the Panasonic CF-VFDU03 USB floppy disk drive (optional) can be used.
Make sure [Legacy USB Support] is enable in the Setup Utility.
After powering off the computer, connect the USB floppy disk drive and restart
the computer.
⇒ Operating Instructions "RAM Module"
You can check whether the RAM module is recognized using [Information]
menu in the Setup Utility. If the RAM module is not recognized, turn the
computer off and reinsert the RAM module.
119