Panasonic CF-Y2 Series Reference Manual page 122

Dealing with Problems (Advanced)
Disk Operations
<Only for CF-Y2 series>
Cannot turn off DVD-ROM & CD-R/
RW drive power
Cannot eject disc
Touch Pad
The cursor cannot be controlled
properly
Unable to input using the touch pad
Sound
The sound is not heard
Volume does not change when
Fn+F5 or Fn+F6 is pressed
The audio is distorted
Was the drive power/open switch slid in succession?
If sliding it in succession, the DVD-ROM & CD-R/RW drive power may not be
able to turn off. In this case, restart the computer.
Is the computer powered on?
<CF-Y2 series>
The drive power/open switch works only when the computer's power is on. Turn
the computer on, and then slide the drive power/open switch to the right.
<CF-W2 series>
Open lever works only when the computer's power is on.
To remove a disc when the computer is powered off, insert a pointed object
(e.g., the bent-out tip of a paper clip, or the tip of a pencil or ballpoint pen) into
the emergency hole, and then move. (
If you are using an external mouse, ensure that the external mouse has been
connected correctly.
Restart the computer by using the keyboard.
, U, and select [Restart] with
(Press
If the computer does not respond to keyboard commands, read "No response"
( page 123).
Has the Setup Utility been used to set [Touch Pad] to [Enable]?
When external mouse drivers are installed (e.g., IntelliMouse), the touch pad
may not be used.
Has the touch pad driver been properly installed?
Try changing the mute by pressing Fn+F4 or Fn+F6.
If the Windows sound function is not active, the volume will not change even if
is displayed.
Audio distortion may occur when operations are performed by pressing Fn in
combination with another key. Stop playing and start again.
122
page 43)
, then press Enter.)