Disassembly Procedures; Control Panel; Mn (Manual) Timer; Cs (Coin Slide) Timer - Maytag MAT12PDA Service Manual

Disassembly Procedures

!

Control Panel

1. Disconnect power supply to unit.
2. Remove top two T-20H Torx screws located on the
front of the control panel.
3. Carefully lay the control panel forwards.
Note: Use a protective cloth to minimize the chance
of scratching the panel on the control console.
MN (Manual) Model Timer
1. Disconnect power supply to unit.
2. Carefully pry the timer knob center cap out of the
knob.
3. Slip the retainer clip off of the timer shaft.
4. Pull the knob, spring and dial off of the timer shaft.
5. Remove screws securing Timer to Control Panel.
6. Remove Control Panel.
CS (Coin Slide) Model Timer
1. Disconnect power supply to unit.
2. Use key to gain access through service door.
3. Remove screw securing timer bracket to meter case.
4. Lift timer and bracket up and forward from the meter
case.
Note: Extra wire (slack) can be fed from the left.
16
WARNING
16022842 Rev. 0
To avoid risk of electrical shock, personal injury or death;
disconnect power to unit before servicing.
5. Squeeze tabs to remove connectors from timer.

Control Board (Microprocessor)

1. Disconnect power supply to unit.
2. Remove Control Panel.
3. Remove four 5/16" nuts from backup plate mounting
studs.
4. Lift board from studs and tilt forward. Don't lose the
spacers.
5. Disconnect touch pad ribbon. Grasp touch pad "tail"
between your thumbs and forefinger. Ribbon can be
pulled out of receptacle.
©2003 Maytag Appliances Company