Reversing Motor Relay; Indicator Light; Lid Switch Assembly (Prior Series 15); Lid Switch Assembly (After Series 15) - Maytag MAT12PDA Service Manual

Disassembly Procedures
!

Reversing Motor Relay

1. Disconnection power supply to unit.
2. Remove all four T-20H Torx screws securing control
panel facia.
3. Disconnect all wires attached to Reversing Motor
Relay.
4. Remove single screw securing relay.
Note: Notice the positioning tab for ease in mounting
and locating relay onto the Control Panel.
Indicator Light (Timer models)
1. Disconnect power supply to unit.
2. Remove Control Panel.
3. Compress tab on the end of the Indicator Light and
remove from back side of Control Panel.
4. Remove wires from assembly.

Lid Switch Assembly (Prior series 15)

1. Disconnect power supply to unit.
2. Remove Control Panel.
3. Remove wires attached to switches and fuse.
4. Remove adjusting screw securing lid switch bracket
to the top cover.
18
WARNING
16022842 Rev. 0
To avoid risk of electrical shock, personal injury or death;
disconnect power to unit before servicing.

Lid Switch Assembly (After series 15)

1. Disconnect power supply to unit.
2. Remove Control Panel
3. Remove wire connector attached to the switch.
4. Lift tab and move switch forward and out.
Lift Tab
©2003 Maytag Appliances Company