Password Settings - Dataprobe iBoot-G2 Manual

Repeat: Set the repeat multiplier, if desired. Set the number from 0 to 999 and either Days, Hours, or
Minutes. To have the schedule repeat every two days, set this number to 2.
Action: Set the event Action; On, Off or Cycle.
Hold/Run: Click Hold to pause the scheduled event. Click Run to re-start the scheduled event.
Delete: Delete the scheduled event.
Click Save to save the current settings. Click Reset to delete any unwanted changes.
7.6.

Password Settings

The iBoot-G2 supports three modes of user and
password operation.
Login Required: This mode supports both User
and Admin users.
password.
Auto Login: This mode does not require a
username of password for the User level operation.
No login challenge will be required for any mode of
operation, until any setup function is requested.
The Admin username and password is required for
any admin functions.
User Disabled: There is no User account. The Admin username and password will be required for
operation and setup functions across all modes of operation. This is the factory default mode.
Two passwords are used by iBoot. In the Login Required mode, The User Password allows access to the
control of iBoot, but not to the Setup functions. Clicking on the Setup button allows the Administrator to log
in. Passwords can be up to 20 characters long and are case sensitive.
Enter the current password then the new password twice to confirm.
Default Credentials
Role
Administrator
User
V130108E
Each user has a settable
Username (fixed)
admin
user
iBoot-G2
Password (user set)
admin
user
Page 14