Final Steps - Kenmore Two-speed high efficiency spray rinse system automatic washer Owner's Manual And Installation Instructions

REVIEW INSTALLATION
Take a few minutes to complete this
checklist. It will help assure you that
you have a proper installation and
increase your satisfaction with your
Kenmore washer.
[ Check electrical requirements.
Be sure you have correct electrical
supply and recommended grounding
method.
[ Check that you have:
• All the tools you started with.
• Removed all packaging materials.
• Removed shipping strap with
three cotter pins.
• Installed all parts listed on
pages 7-9.
[ Check that:
• The washer is level.
• The nuts on the front legs are tight.
[ Check that the water faucets are
turned on.
FINAL STEPS
V Plug into a grounded 3 prong outlet.
V Remove the blue protective film on the
console and any tape remaining on
washer.
[ Take a few minutes and read the
"OPERATING YOUR WASHER"
section to fully understand your new
washer, Then, start the washer and
allow it to complete the ULTRA CLEAN
or 2ND RINSE cycle.
2O