Final Steps - Kenmore Three-Speed Triple Dispenser Automatic Washers Owner's Manual & Installation Instructions

REVIEW INSTALLATION
Take a few minutes to complete
this checklist. It will help assure you
that you have a proper installation
and increase your satisfaction with
your Kenmore washer.
[]
[]
Check electrical requirements.
Be sure you have correct electrical
supply and recommended grounding
method.
Check that you have:
• All the tools you started with.
• Removed all shipping materials.
• Removed shipping strap with
three cotter pins.
• Installed all parts listed on
pages 6-8.
[] Check that:
• The washer is level.
• The nuts on the front legs are tight.
[] Check that the water faucets are
turned on.
=
FINAL STEPS
[]
[]
Plug power supply cord into
grounded outlet.
Flemove the blue protective film on
the console and any tape remaining
on washer.
[]
Take a few minutes and read the
Operating Instructions (pages 20-30)
to fully understand your new washer.
Then, start the washer and allow it to
complete the ULTRA CLEAN Cycle.
19