Remove Shipping Strap - Kenmore Two-speed high efficiency spray rinse system automatic washer Owner's Manual And Installation Instructions

B. REMOVE SHIPPING STRAP
Removing the shipping strap is
necessary for smooth operation.
If the shipping strap is not removed,
the washer will make excessive noise,
STEP 2. Pull firmly to remove the end of
the shipping strap that remains pinned
to the back of the washer. This will
release the rear self-leveling legs.
Pin
To prevent floor damage, set washer
onto cardboard before moving across
floor, Move washer close to its final
location.
STEP 1. Do not cut yellow strap, Pull
yellow strap firmly, until completely
removed from washer. Depending on
your model, there should be either two
or three cotter pins on the end of the
shipping strap when it is pulled out of
the washer. The electrical plug is
attached to this shipping strap.
Electrical plug
Shipping strap
© ©
STEP 3. Cut the shipping strap about
16 in (40 cm)from plug end. Look for
the words "CUT HERE." Discard end
with the cotter pins. Slide remainder
of shipping strap from the electrical
plug. You will use this to secure the
drain hose.
PULL
Pin
14