P-792H V2 Access And Login - ZyXEL Communications P-792H User Manual

Chapter 38 Troubleshooting
Inspect your cables for damage. Contact the vendor to replace any damaged
3
cables.
Turn the P-792H v2 off and on.
4
If the problem continues, contact the vendor.
5

38.2 P-792H v2 Access and Login

I forgot the IP address for the P-792H v2.
The default IP address is 192.168.1.1.
1
If you changed the IP address and have forgotten it, you might get the IP address
2
of the P-792H v2 by looking up the IP address of the default gateway for your
computer. To do this in most Windows computers, click Start > Run, enter cmd,
and then enter ipconfig. The IP address of the Default Gateway might be the IP
address of the P-792H v2 (it depends on the network), so enter this IP address in
your Internet browser.
If this does not work, you have to reset the device to its factory defaults. See
3
Section 1.5 on page
I forgot the password.
The default admin password is 1234, and the default user password is user.
1
If this does not work, you have to reset the device to its factory defaults. See
2
Section 1.5 on page
I cannot see or access the Login screen in the web configurator.
Make sure you are using the correct IP address.
1
• The default IP address is 192.168.1.1.
• If you changed the IP address
address.
398
28.
28.
(Section 7.2 on page 87), use the new IP
P-792H v2 User's Guide