Ftp File Upload Command From The Dos Prompt Example; Ftp Session Example Of Firmware File Upload - ZyXEL Communications P-792H User Manual

Chapter 35 Firmware and Configuration File Maintenance
35.5.3 FTP File Upload Command from the DOS Prompt
Example
Launch the FTP client on your computer.
1
Enter "open", followed by a space and the IP address of your P-792H v2.
2
Press [ENTER] when prompted for a username.
3
Enter your password as requested (the default is "1234").
4
Enter "bin" to set transfer mode to binary.
5
Use "put" to transfer files from the computer to the P-792H v2, for example, "put
6
firmware.bin ras" transfers the firmware on your computer (firmware.bin) to the
P-792H v2 and renames it "ras". Similarly, "put config.rom rom-0" transfers the
configuration file on your computer (config.rom) to the P-792H v2 and renames it
"rom-0". Likewise "get rom-0 config.rom" transfers the configuration file on the P-
792H v2 to your computer and renames it "config.rom." See earlier in this chapter
for more information on filename conventions.
Enter "quit" to exit the ftp prompt.
7

35.5.4 FTP Session Example of Firmware File Upload

Figure 212 FTP Session Example of Firmware File Upload
More commands (found in GUI-based FTP clients) are listed earlier in this chapter.
Refer to
TFTP and FTP over WAN.
380
331 Enter PASS command
Password:
230 Logged in
ftp> bin
200 Type I OK
ftp> put firmware.bin ras
200 Port command okay
150 Opening data connection for STOR ras
226 File received OK
ftp: 1103936 bytes sent in 1.10Seconds 297.89Kbytes/sec.
ftp> quit
Section 35.3.5 on page 372 to read about configurations that disallow
P-792H v2 User's Guide