ZyXEL Communications P-792H User Manual page 65

Table 12 Network > WAN > Internet Access Setup (continued)
LABEL
Connect on
Demand
Max Idle Timeout
Service Type
Service Mode
Service Type
Enable Rate
Adaption
Transfer Max Rate
(Kbps)
Transfer Min Rate
(Kbps)
Standard Mode
Modulation
Apply
Cancel
Advanced Setup
P-792H v2 User's Guide
DESCRIPTION
Select Connect on Demand when you don't want the connection up
all the time and specify an idle time-out in the Max Idle Timeout
field.
Specify an idle time-out in the Max Idle Timeout field when you
select Connect on Demand. The default setting is 0, which means
the Internet session will not timeout.
Use 2-wire mode for the DSL connection. The maximum data rate is
up to 5.7 Mbps.
Indicate whether the P-792H v2 is the server or the client in the DSL
connection. Select Server if this P-792H v2 is the server in a point-to-
point application. Otherwise, select Client.
This field is enabled if Service Type is Server. Indicate whether or
not the P-792H v2 can adjust the speed of its connection to that of the
other device.
This field is enabled if Service Type is Server. Set the maximum rate
at which the P-792H v2 sends and receives information. The actual
transfer rate will be between this value and the minimum transfer rate
you configure.
This field is enabled if Service Type is Server. Set the minimum rate
at which the P-792H v2 sends and receives information. The actual
transfer rate will be between this value and the maximum transfer
rate you configure.
This field is enabled if Service Type is Server. Select the operational
mode the P-792H v2 uses in the DSL connection. ANSI (ANNEX_A)
refers to connections over POTS and ETSI (ANNEX_B) refers to
connections over ISDN lines.
Select the modulation supported by your ISP.
Click this to save your changes.
Click this to restore your previously saved settings.
Click this to display the Advanced WAN Setup screen and edit more
details of your WAN setup.
Chapter 6 WAN Setup
65