ZyXEL Communications P-792H User Manual page 318

Chapter 29 Static Route Setup
Now, enter the index number of the static route that you want to configure.
Figure 150 Menu 12.1.1: Edit IP Static Route
The following table describes the fields in this screen.
Table 120 Menu 12.1.1: Edit IP Static Route
FIELD
Route #
Route Name
Active
Destination IP
Address
IP Subnet
Mask
Gateway IP
Address
Metric
Private
Once you have completed filling in this menu, press [ENTER] at the message "Press
ENTER to Confirm..." to save your configuration, or press [ESC] to cancel.
318
Menu 12.1.1 - Edit IP Static Route
Route #: 1
Route Name= ?
Active= No
Destination IP Address= ?
IP Subnet Mask= ?
Gateway IP Address= ?
Metric= 2
Private= No
DESCRIPTION
This is the index number of the static route that you chose in menu 12.
Enter a descriptive name for this route. This is for identification purposes
only.
This field allows you to activate/deactivate this static route.
This parameter specifies the IP network address of the final destination.
Routing is always based on network number. If you need to specify a
route to a single host, use a subnet mask of 255.255.255.255 in the
subnet mask field to force the network number to be identical to the host
ID.
Enter the IP subnet mask for this destination.
Enter the IP address of the gateway. The gateway is an immediate
neighbor of your P-792H v2 that will forward the packet to the
destination. On the LAN, the gateway must be a router on the same
segment as your P-792H v2; over the WAN, the gateway must be the IP
address of one of the remote nodes.
Enter a number from 1 to 15 to set this route's priority among the P-
792H v2's routes (see Section 6.6 on page
the higher priority the route has.
This parameter determines if the P-792H v2 will include the route to this
remote node in its RIP broadcasts. If set to Yes, this route is kept private
and not included in RIP broadcast. If No, the route to this remote node
will be propagated to other hosts through RIP broadcasts.
79). The smaller the number,
P-792H v2 User's Guide