ZyXEL Communications P-792H User Manual page 38

Chapter 3 Status Screens
Each field is described in the following table.
Table 4 Status Screen
LABEL
Refresh Interval Select how often you want the P-792H v2 to update this screen.
Apply
Device Information
Host Name
Model
Number
MAC
Address
ZyNOS
Firmware
Version
DSL
Firmware
Version
WAN Information
DSL Mode
IP Address
IP Subnet
Mask
Default
Gateway
VPI/VCI
LAN Information
IP Address
IP Subnet
Mask
DHCP
Security
Firewall
38
DESCRIPTION
Click this to update this screen immediately.
This field displays the P-792H v2 system name. It is used for
identification. You can change this in the Maintenance > System >
General screen's System Name field.
This is the model name of your device.
This is the MAC (Media Access Control) or Ethernet address unique to
your P-792H v2.
This is the current version of the firmware inside the device. It also
shows the date the firmware version was created. Click this to go to the
screen where you can change it.
This is the current version of the device's DSL modem code.
This is the DSL standard that your P-792H v2 is using.
This is the current IP address of the P-792H v2 in the WAN. Click this to
go to the screen where you can change it.
This is the current subnet mask in the WAN.
This is the IP address of the default gateway, if applicable.
This is the Virtual Path Identifier and Virtual Channel Identifier that you
entered in the wizard or WAN screen.
This is the current IP address of the P-792H v2 in the LAN. Click this to
go to the screen where you can change it.
This is the current subnet mask in the LAN.
This field displays what DHCP services the P-792H v2 is providing to the
LAN. Choices are:
Server - The P-792H v2 is a DHCP server in the LAN. It assigns IP
addresses to other computers in the LAN.
Relay - The P-792H v2 acts as a surrogate DHCP server and relays
DHCP requests and responses between the remote server and the
clients.
None - The P-792H v2 is not providing any DHCP services to the LAN.
Click this to go to the screen where you can change it.
This displays whether or not the P-792H v2's firewall is activated. Click
this to go to the screen where you can change it.
P-792H v2 User's Guide