Bridge Wan Connection Setup; Igmp Multicast - ZyXEL Communications P-663HN-51 User Manual

Chapter 5 WAN Setup
Table 18 Advanced Setup > WAN > Add (3: IPoA) (continued)
LABEL
Use the following
default gateway
Use the following
DNS server
addresses
Back
Next

5.14 Bridge WAN Connection Setup

When you select bridge in the second WAN setup add (or edit) screen, this screen
displays next. Use this screen to configure bridge connection settings.
Figure 29 Advanced Setup > WAN > Add (3: Bridge)
The following table describes the labels in this screen.
Table 19 Advanced Setup > WAN > Add (3: Bridge)
LABEL
Enable Bridge
Service
Service Name
Back
Next

5.15 IGMP Multicast

Traditionally, IP packets are transmitted in one of either two ways - Unicast (1
sender - 1 recipient) or Broadcast (1 sender - everybody on the network).
70
DESCRIPTION
The default is a neighboring router that helps the ZyXEL Device
forward traffic to its destination. Select this option and enter the
gateway's IP address or select the WAN interface to use to connect to
it.
The ZyXEL Device uses a DNS server to resolve a domain name (find
the numeric IP address associated with the domain name). Select this
option. Enter the DNS server addresses from the ISP in the fields
below.
Click this to return to the previous screen.
Click this to go to the following screen.
DESCRIPTION
Select this to turn on bridging for this DSL connection.
If the ISP specified a service name to use for the DSL connection,
enter it here. Otherwise leave the default generated text.
Click this to return to the previous screen.
Click this to go to the following screen.
P-663HN-51 User's Guide