Wan Information - ZyXEL Communications P-663HN-51 User Manual

4.2 WAN Information

Click Device Info > WAN to open the following screen. Each row in the table
displays information about one of the ZyXEL Device's WAN connections.
Figure 11 Device Info > WAN
The following table describes the labels in this screen.
Table 4 Device Info > WAN
LABEL
Port/VPI/VCI
VLAN Mux.
Con. ID
Category
Service
Interface
Protocol
IGMP
QoS
State
Status
IPv4 Address This is the WAN connection's IP (version 4) address.
P-663HN-51 User's Guide
DESCRIPTION
This field displays the WAN connection's DSL port, Virtual Path Identifier,
and Virtual Channel Identifier. The DSL port is always 0 because the DSL
ports are bonded into a single logical port.
This field shows whether or not VLAN multiplexing is enabled. VLAN
multiplexing allows multiple separate WAN connections within the same
PVC.
This is the number of the WAN connection.
This is the ATM traffic class the WAN connection is using.
This displays the connection type, DSL port, Virtual Path Identifier, and
Virtual Channel Identifier. For the connection types, pppoe stands for
PPPoE, ipoa stands for IPoA, pppoa stands for PPPoA, mer stands for MAC
Encapsulated Routing, and br stands for bridging.
This field displays the name of the WAN connection, followed by the DSL
port, Virtual Path Identifier, and Virtual Channel Identifier.
This is the type of network protocol the WAN interface is using for IP over
Ethernet.
This is whether or not the WAN connection is using IGMP multicast (if
available).
This is whether or not packet level QoS is enabled for the WAN connection.
This is whether or the WAN connection is enabled.
This is the WAN connection's current ADSL line state.
Chapter 4 Device Information
39