Wan Atm Pvc Configuration And Qos - ZyXEL Communications P-663HN-51 User Manual

5.4 WAN ATM PVC Configuration and QoS

Click Advanced Setup > WAN > Add (or Edit) to open the following screen. Use
this screen to configure ATM PVC settings and enable or disable QoS. The screen
differs by the service category.
See Section 5.1 on page 53
Figure 23 Advanced Setup > WAN > Add
The following table describes the labels in this screen.
Table 13 Advanced Setup > WAN > Add
LABEL
ATM PVC
Configuration
VPI
VCI
VLAN Mux.
802.1Q VLAN ID
P-663HN-51 User's Guide
for more information.
DESCRIPTION
The PORT (interface), VPI (Virtual Path Identifier) and VCI (Virtual
Channel Identifier) define an ATM PVC (Permanent Virtual Circuit).
Refer to the appendix for more information.
Enter the VPI assigned to you for this WAN connection.
Enter the VCI assigned to you for this WAN connection.
Select the check box to use VLAN multiplexing to allow multiple
separate protocols to use the same PVC. Selecting this enables IEEE
802.1q. Separate VLANs can be used to give different priorities to the
traffic from different ports.
When you enable VLAN multiplexing, type the VLAN ID that the ZyXEL
Device is to add to the traffic sent through this WAN connection.
Chapter 5 WAN Setup
57