Class Setup - ZyXEL Communications P-663HN-51 User Manual

10.5 Class Setup

Click Advanced > Quality of Service > QoS Classification to open the
following screen.
This screen lists the QoS classifiers. A classifier groups upstream traffic into data
flows according to specific criteria such as the source address, destination
address, source port number, destination port number or incoming interface. For
example, you can configure a classifier to select traffic from the same protocol
port (such as Telnet) to form a flow. The classifier also assigns a specific QoS
queue, DSCP mark, and/or IEEE 802.1p tag.
Figure 51 Advanced > Quality of Service > QoS Classification
The following table describes the labels in this screen.
Table 38 Advanced > Quality of Service > QoS Classification
LABEL
Class Name
MARK
DSCP Mark
Queue ID
802.1P Mark
TRAFFIC
CLASSIFICATION
RULES
Lan Port
Protocol
DSCP
Source Addr./
Mask
Source Port
P-663HN-51 User's Guide
DESCRIPTION
This is the name of the classifier.
These columns are the QoS setting the ZyXEL Device uses for or
assigns to the packets of upstream traffic that match this QoS
classifier.
This is the DSCP mark the ZyXEL Device assigns to the packets of
upstream traffic that match this QoS classifier.
This is the QoS queue the ZyXEL Device uses for the packets of
upstream traffic that match this QoS classifier.
This is the IEEE 802.1p mark the ZyXEL Device assigns to the packets
of upstream traffic that match this QoS classifier.
These columns identify the upstream traffic to which the QoS classifier
applies.
This is the source Ethernet port of the traffic.
This is the type of packets.
This is the DSCP mark.
This is the IP address (and optionally the subnet mask) of the device
that sent the traffic.
This is the port number that a device used to send the traffic.
Chapter 10 Quality of Service (QoS)
109